Rcd330 vcds long code helper MQB active
|
12-03-2018, 12:49 PM
Thank you for posting this.
Perhaps my problems with Siri volume could be related to incorrect coding? I have Byte 0 Bit 3 enabled as my car has parking aid, but this did not display on factory fit RNS315 Also, Byte 6 Bit 4 set to 0C Tiguan 5N2 but my car is 5N Tiguan - I had changed this to get correct SUV graphic on OPS display Do you think this could be related?
12-03-2018, 01:16 PM
(12-03-2018, 12:49 PM)ADW1 Wrote: I am not sure tiguan but i think yes it will change .. try it. If not back to default.. for siri no any option on vcds
13-03-2018, 12:40 PM
I dont know why using vcds (17.8) rcd330 accepted the new long coding (with dynaudio selected) but later the coding continues the old, and not the new one ...
Someone knows why? Im a little bit lost
13-03-2018, 01:19 PM
Did you reset RCD since recoding?
I have a feeling this rewrites coding to defaults
13-03-2018, 05:29 PM
(13-03-2018, 01:19 PM)ADW1 Wrote: Yes, a lot of times, pressing the power button until 10 seconds but nothing changes. steering wheel buttons don't work too
15-03-2018, 06:36 PM
i just tried to alter the ops image in byte 06. i was able to get 3 different car type, i think something like passat, tiguan an one i could not recognize. But getting Transporter was not possible. So i think not all types are implemented in the rcd330 firmware.
But i was able to deactive the rear camera so i didn*t get any new errors
26-03-2018, 11:01 PM
Hi Gokturks,
Can you explain what some of the coding is for... I'm confused by the monitoring and active speaker settings - how do I know what I should set for my car (2009 Passat B6)?
27-03-2018, 04:52 AM
(15-03-2018, 06:36 PM)bastardop Wrote: I had the issue to set ops golf hatchback image. My solution was to change ops settings to Golf hatchback in car CAN bus (was on default). Then i set radio ops to standart via can. Reset radio and it works. You should try it this way. |
Users browsing this thread: |
1 Guest(s) |